Is there a standard that state how many zones are to appear on the different engineering sheet sizes? Does it matter if the letters go on the x-axis or y-axis? Are the zones dividing the whole sheet of paper or just the drawing area?
I ended up just modeling a rivet as a part in the crushed state. I am going to have to make a no hardware rep to speed things up. Thanks for the information.
PS
We currently have our rivets modeled with in the uncrushed state with a huck on the end and the mandrel in tact. When we place the rivet we put one in and use flexibility to remove the mandrel and set the crush depth to the desired length. We then can use the repeat command to place the rivet in...
