Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Himanshmishra

  1. Himanshmishra

    Dimension rectangular through cutouts

    Thanks for the responses guys, Sorry I realized my post was random and didn't provide much information or introduction. I've just started out fresh out of uni hence I'm still learning the ropes. I know some of you legends here have decades of experience [I've been following this forum for a...
  2. Himanshmishra

    Dimension rectangular through cutouts

    Been trying to find the best possible way to callout rectangular through cutouts positioned at the corners of a square cross section? The cutouts are angled to be along the diagonals of the square. Is it acceptable to say "4X THRU 10x13 slot" ? What about the angle? Any help on the matter is...
See more

Part and Inventory Search

Back
Top