Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by HF

  1. HF

    Help me choose steel....please...

    Thanks...I don't attribute the problem much to the welding process becuase I have run bars through the oven without welding them and they still bend. I am really looking for a steel that I can buy (i.e. 1018 cold-rolled steel) that will have minimum deformation at that temperature. Annealing...
  2. HF

    Help me choose steel....please...

    Hi. I am searching for a low-carbon steel that will allow me to do the following. First, the dimensions of the steel bar I will be using are 1/4" by 1/4" by 48". I will be welding this bar to other pieces of steel, painting it, and then baking it in an oven at 500 degrees F for...
  3. HF

    Steel Selection...

    HF (Visitor) Jun 21, 2001 Hi. I am searching for a low-carbon steel that will allow me to do the following. First, the dimensions of the steel bar I will be using are 1/4" by 1/4" by 48". I will be welding this bar to other pieces of steel, painting it, and then baking it in...
  4. HF

    Help choosing steel...

    Hi. I am searching for a low-carbon steel that will allow me to do the following. First, the dimensions of the steel bar I will be using are 1/4" by 1/4" by 48". I will be welding this bar to other pieces of steel, painting it, and then baking it in an oven at 500 degrees F for...
See more

Part and Inventory Search

Back
Top