Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by hephestus

  1. hephestus

    Combining Sweeps ?

    Hi Jeff, I initially built this grip with surfaces, but couldn't thicken the surface. The "Check feature would alway reveal 1 "Open Surface". If I fixed the open surface that was pointed out and ran check again, there would aways be 1 more "Open Surface". I finally gave up and tried this...
  2. hephestus

    Combining Sweeps ?

    Sorry, I was having problems posting all three images at once.
  3. hephestus

    Combining Sweeps ?

    Thanks for the rapid reply!. The first image shows the two outer profiles. The second image shows the Sweep that uses the two outer profiles as guide curves. The third image shows the gaps that prevent me from merging. Thanks!
  4. hephestus

    Combining Sweeps ?

    Hi All, I am new to this forum and I am sure this question has been asked a million times, but I have not been able to find the answer in the archives. I am having problems combining swept solid bodies together. I am building a simple hand grip for injection molding. There are three swept...
See more

Part and Inventory Search

Back
Top Bottom