Out of topic:
If I have straight duct with VAV on it, if I will compute for the total static pressure of straight duct - do i need to add the static pressure of VAV (coil/box/etc) up to the supply diffuser or just at the entry of VAV box? So from the VAV supply duct to the supply diffuser will...
This is the first time I will design heating coil since most of the project I design don't need heating.
When I do cooling coil selection - I used psychrometric chart to select the coil in/out condition (computing mix air, use 55f supply air, 7c 12c chilled water entering & leaving, etc). I...
Need to know where can I found VAV basic to complicated information - that's including control and other accessories information.
I have project that we need to commission that's include lots of VAV.
Another question: if I need to get the VAV total static pressure is it the same procedure as...
The room is pretty hot....what's the corrective action, increased the exhaust fan?
how's 10 ~ 15times/hr ventilation rate? Ashrae Mechanical Room recommended ventilation rate is too low.
JTE,
If the Board decides that my school qualified as "Regionally Acredited" and granted only 3 or 4 or 5 credits, but not qualified for the education requirement (6credits). Will they add my 10 years of experience as Mechanical Engineer in my country just to qualify for EIT exam?
Btw, I...
Hi Kenat,
Correct me if i'm wrong, 6 credit based on education, means 6years in school?
What does "Regional" (accreditation) means if i get my Bachelor diploma from other country?
Sorry guys I'm not familiar with NYS Prof. rules. If i got time I'll call them but for now your help is much more...
jte,
thanks for the link.
based on the link below, can somebody advise me if i'm eligible to take the Part A examination here in NY State.
I completed my Bachelor of Science in Mechanical Engineering in my Country (Asia) and working as Mechanical Engineer (with license) for 10years in...
@scottyuk
In which country? USA (NY)
Accredited by whom, and to what requirements? NY State
@chrisduncan
I'm from other country (ASIAN) with licensed Mechanical Engineer. I heard that I need to go to school for 2more years to qualify me of getting EIT (Engineering in Training) Examination. This...
thank you for the reply.
is there any step by step procedure to do commissioning for New Building and Existing Building?
I found the link lots of checklist, forms, etc. but i can't find what's the first step in testing and commissioning.
example of what i'm looking for new building...
