Eng-Tips is the largest forum for Engineering Professionals on the Internet.

Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!

Register Log in
  • Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Henry Chiansky

  1. H

    Polyamide to EPDM rubber bonding

    Thanks for the suggestion! We did another round of injection molding, focusing on roughening the surface and thoroughly cleaning the cable jacket. The results were promising, and the cable passed the testing. Unfortunately, adding a strain relief isn't feasible for this product due to space...
  2. H

    Polyamide to EPDM rubber bonding

    Thank you for your response. We will definitely explore this opportunity and reach out to the cable manufacturer. However, I would still prefer to approach this from a more general perspective, as the cable being used is standardized, and the compound of the outer jacket must remain consistent...
  3. H

    Polyamide to EPDM rubber bonding

    We have been overmolding rubber cables (specifically SJOOW and H07RN-F types) using a low-pressure molding process. The material used for molding is polyamide, which is typically the go-to polymer for overmolding applications. However, since we are working with rubber cables, achieving optimal...
See more

Part and Inventory Search

Back
Top