Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Heinrich3333

  1. Heinrich3333

    Question about lofting techniques (probably)

    Hey you guys, and thank you for all the interesting replies. :) I tried going forward with SvenBom`s method because it looked easy, and I think I`ve got what I need. Even so, stars for everyone! Again, thank you all very much! -Henrik
  2. Heinrich3333

    Question about lofting techniques (probably)

    Thank you for your reply. :) We`re closing in, but even so the optimal design would be if the shape was a constant R25 half-circle going with a constant angle out from 122 mm to 97 mm. Is that even possible? -Henrik
  3. Heinrich3333

    Question about lofting techniques (probably)

    Right, the history is a bit messy, but what the hell, here is a part of the housing. The passage I speak of is the passage where the circles extruded on the sides "meet" the half-circles (on the up and downsides) of the extruded figures on the inside. Instead of the height difference I want a...
  4. Heinrich3333

    Question about lofting techniques (probably)

    Apparently I could only post one file at a time. Here is the one referenced in the post.http://files.engineering.com/getfile.aspx?folder=cdc42e80-3c97-45ed-a518-1213405275ab&file=noname.gif
  5. Heinrich3333

    Question about lofting techniques (probably)

    I`m a relatively new user in NX, so please bear with me. :) I`m modeling a valve housing, as shown in the attached sketches. The inner extruded feature has a height ("diameter") on 122 and the half-circles on the top and the bottom are size R25, the hole on the outside has a diameter of 95...
See more

Part and Inventory Search

Back
Top