Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by hdsi44

  1. hdsi44

    What kind of fittings are these?

    https://www.mcmaster.com/tube-fittings/plastic-quick-disconnect-tube-couplings-for-air-and-water/
  2. hdsi44

    Distance with a tolerance in degrees?

    Perhaps it is referring to draft? Maybe: 3,65 +1° (of draft) /S (Per side)?
  3. hdsi44

    Using cast hole as a datum

    OK, thanks a lot. It looked redundant to me, but I can see that a assumption must be made.
  4. hdsi44

    Using cast hole as a datum

    KENAT, please forgive my ignorance, I thought that if the holes appeared to line up and there was no other indication they don't, then the one dimension governed both holes. Why do you need to extend the leader lines of add the 2X. Is that is the standard? If so, where? Thanks,
See more

Part and Inventory Search

Back
Top Bottom