Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Hass008

  1. Hass008

    is electropolishing allowed after hydrotest ?

    See UG-99(a)(1) for your answer.
  2. Hass008

    UG-44, B16.5 Flanges and receiving inspection documentation

    Hi folks, looking to gather some thoughts. When a VIII-1 manufacturer receives B16.5 (and B16.47) flanges, what is recorded during receipt inspection, and what type of inspection occurs? UG-44 requires that B16.5 flanges meet all dimension requirements of B16.5 with the exception of ID. How is...
  3. Hass008

    Marking on Zinc coated Fasterners, SA-193/194

    Hi guys, Supplementary Requirements (S13) in SA-193 states that all Zinc coated fasteners shall be marked with ZN. However, these are supplementary requirements they're only applicable when specified. Our AI requires that all SA-193/194 fasteners have the ZN marking. Our supplier says it's not...
See more

Part and Inventory Search

Back
Top Bottom