Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Harpreet13

  1. Harpreet13

    Steel Manual: kdes vs kdet

    Thanks DrZoidberWoop
  2. Harpreet13

    GD&T Related but more on Measuring technique question

    Hi, I have seen drawings with circumference location optional but in those cases it was a round part i.e. machined pipe, there was a drain hole at a angle. if that's the case then I believe it can be anywhere on the pipe circumference. If I have to inspect this diameter looking at the...
See more

Part and Inventory Search

Back
Top