Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by hannes964

  1. hannes964

    still floor meshing

    Hi folks, i’m still really unhappy by meshing floors with areas. I handled to mesh the geometry manually, which is irregular, in six big quads. So far the model runs without warnings. I tried to generate a finer mesh by dividing the areas into sub-elements to get the proper deformation of my...
  2. hannes964

    floor meshing

    thanks for the answer. the command merge points is a powerful command which i have not known. thanks. but i'm still not able to fix the following warning: 2. UG, F4 & F413 are too close. Check at (179,622,296,385,3,15) 2. UG, F413 & F414 are too close. Check at (161,803,262,212,3,15) Check...
  3. hannes964

    floor meshing

    Hello, I try to mesh manually a floor of an irregular geometry by dividing the area at lines (shell elements). When I check the model, I get the warning message: areas "are too close at points...". Has anyone an idea how I can fix this warning. I'm not able to mesh this geometrie proper. In...
See more

Part and Inventory Search

Back
Top