We do not plan to do any structural analysis or comply with design codes. We would like to do the 3-D modeling to check for any fouling of components. eg platforms fouling with pipes or inlet outlet manifolds etc. Also evetually we would want to have a capability to make detail fabrication 2-D...
Hello,
Our firm is trying to find a 3-D modeling software that best suites our requirement to make a 3-D model of fired heaters including the
structural members,
stiffeners,
shell plate
convection & radiant coils etc.
Platforms
refractory
We are trying to find a software to model the entire...
Hello,
Our firm is trying to find a 3-D modeling software that best suites our requirement to make a 3-D model of fired heaters including the
structural members,
stiffeners,
shell plate
convection & radiant coils etc.
Platforms
refractory
We are trying to find a software to model the entire...
Hello,
I am working on a project with one of our european clients. S275JR & S355 JR are the two most common grades used in the european structural steel industry. I want to know if UPNs, IPNs, angle irons & flat stiffener bars are easily available in the above grades in the european steel...
