Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by hafhaq
-
Wear of PTFE (Teflon) for Spinner Support
I'm considering using Teflon as a support block pressed against a spinning cylinder in a roll forming machine. Currently it uses a steel roller, but it is a nuisance and expensive to replace the bearings, the roller, as well as the fact that the design is poor causing leaks in the hydraulic...- hafhaq
- Thread
- Replies: 2
- Forum: Chemical coatings engineering
