Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by gursh

  1. gursh

    garage trusses

    i have attached a diagram to explain may be some body understands it with measurements they are with 5inch i have 5 truses that need to be cut 5ftx10ft 5ft length of the main cord the cords are 2ft apart so 5 of the will give me...
  2. gursh

    garage trusses

    Thanks to all I would not cut off any trusess until I have a support for it the many cord is 24 ft with verticle angled support at 8 ft I have involved a roofing company that claim they have modified roofs such as mine if I can get drawing as to where and what angle a support is needed then...
  3. gursh

    garage trusses

    thank you very much..just to make it more clear i made a rough diagram hope it makes sense and if you can give me some idea if it is possible. the centre is 2ft
  4. gursh

    garage trusses

    I should be more clear as to what i on tend to do 1) there is going to be no load what so ever pulling down on the trusses 2) I just want to cut a section out may be 5x10 section, so that when I lift a vehicle up with a 2 poster car lift , the roof of the car goes into the celing of my garage (...
  5. gursh

    garage trusses

    i have 9'7" celling in the garage, where i need to install a hoist, i need to cut 2 or 3 trusses ,is this possible i would like some advise , there must be a way to support 3 trusses
See more

Part and Inventory Search

Back
Top