Quark,
All my silly questions have been answered by an animation that i came across, but thats' not to say that your help wast appreciated, thanks once again. I have included a link for you if you like...
Thank you quark, a great help. Your replies have made me realise some now obvious points in my questions.
Please find a simple schematic with some further questions.
Please bare with me i know it must be frustrating for you and i do apologise...
I am a building services project manager working on the early design stages of a building that was to use ground source heat pumps. The main contractor has discovered that they are over budget and have asked for value engineering solutions to lower the costs. We have been asked to carry out a...
All,
Thank you for the support. On review of my original thread I can see the trap I set up for my self. I appear to have made light of the processes involved in making the assessment. I will make the point of sending the information to two SEs' next time in order to make the judgment.
Ron, I...
I have a thermal insulation spec that asks for cold draw to be prevented around supporting bracketry on pipework supports. My interpretation of this is that due to the fact that part of the bracket is outside of the thermal insulation the intention would be to keep the bracket from actually...
I feel the above threads have enabled people to vent some frustrations that have built up over the years...I can understand your points and do sympathize with your predicament. Mike, in your case 12 years of input from your self to have the title of Engineer, I understand. The reason for me...
Hi, I am a Project Building Services Engineer and require some simple formulas for calculating the size of steel sections for supporting pipe, duct and plant etc. So point loads and spread loads etc. Some structured reading would also be useful.
