Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by gruffalo
-
Assistance reverse engineering a spline
I'm not sure that is correct. The included angle is closer to 51 deg. Attached is what I'm looking at. These dimensions are from a model created by a scan of the part. Again, any help would be...- gruffalo
- Post #4
- Forum: Gear and Pulley engineering
-
Assistance reverse engineering a spline
I am working on reverse engineering an internal spline. The major diameter is 44.56mm, the minor is 40.30, there are 38 teeth. I know it is a metric spline, but am having issues finding a stardard spline size that matches. Any assistance would be appreciated.- gruffalo
- Thread
- Replies: 3
- Forum: Gear and Pulley engineering
