Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by GriVaOnLine
-
Max injection rate through the choke
Thanks LittleInch, but I'm working in Kazakhstan and I'm not sure I could find Cv curve for simple choke bean (3 cm lenth). Futher, Cv is applicable only for pressure ratio lower than critical: above the critical PR the flow is constant and I wish calculate this value in Pipesim when I simulate...- GriVaOnLine
- Post #3
- Forum: Petroleum production engineering
-
Max injection rate through the choke
Hello colleagues! I have some challenge calculating water injection wells. Some wells with low Pres are absorbing and the injection rate is thus constrained by the chokes (of course cavitation and erosion is inevitable in this way but we could not decrease injection pressure). How could I...- GriVaOnLine
- Thread
- Replies: 3
- Forum: Petroleum production engineering
