bottom of the material focus point, high pressure N2 6-8kg(depending on machine capabilities)Limited to about .125 inch material. full power, freq, duty. feed rate start @ half of mild steel fedd rate and go up as far as you can have a decent cut
Another way to do it is to keep the head up @ low power(enough to burn away the coating)and outline the part, then go back and cut it with the regular parameters.
Has anyone had any cutting problems btween these two materials in the same thickness? We were having trouble cutting a 1010 .625" thickness an a Trumpf 4000W machine. When we switched to the A50 in the same thickness, it cut fine with the stock tech tables.
Any feed back would be appreciated
