Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

greenimi's latest activity

  • greenimi
    greenimi replied to the thread Fig 7-39/2018 question.
    Based on the figure posted by SeasonLee figure 4-4 / ASME Y14.5.1-2019: IF I am going to force the red line to overlap with the blue...
    • 4-4 - Copy (2).jpg
  • greenimi
    greenimi replied to the thread General Profile Tolerance Interpretation.
    Just to make sure we get the correct historical perspective. THE picture CH attached is from the draft version of Y14.5-2018. Again...
  • greenimi
    greenimi replied to the thread Runout Tolerance Applied on an Assembly.
    Burunduk, In your last reply/ picture posted, do you think if B and C are switched in the DRF, would still be a valid callout? I mean...
Show older items

Part and Inventory Search

Back
Top Bottom