Recent content by graymj

I'm not sure of your cost range but give Dynavista Die Design a look! -mike https://pdf.directindustry.com/pdf/fti-forming-technologies-incorporated/dynavista-die-structure/112599-664746.html

Look into Polyworks or Geomagic!

Hello guy's give this CATScript a shot! Run it from the Generate Docunment function from within the CATProcess menu. Good luck! -mjghttp://files.engineering.com/getfile.aspx?folder=ff31ed9b-e0d2-4919-8ad3-c24393449e4d&file=SHOPFLOOR_DOC.CATScript

Just follow the steps in the attached file! Mikehttp://files.engineering.com/getfile.aspx?folder=d1e71087-2d3d-436d-936a-17c2057f7d53&file=10-5-2011_1-42-26_PM.jpg

Give this a shot!http://files.engineering.com/getfile.aspx?folder=1ac0e0b7-fe4c-41ed-82be-f1ebfb532bc7&file=ChangeToolAxis.zip

Question, in Catia v5 r16 is there a command to offset a 3D curve with a variable offset distance? Similar to the Global Flange command for surfaces! On the Automotive Class A workbench under Shapes

HI All A very good overview on STL's, Scanning and Etc... http://www.gsd.harvard.edu/inside/cadcam/catiav5/ Good Luck! MG

Hi Then the Steps outlined, will work! I use them all the time for manual designed dies into cad, die repairing and etc...

HI It depends on what information you need, Catia v5 has three workbenches that are dictated to reverse engineering, in which you could build a curve network then apply surfaces to the point cloud or polygon mesh model. But if you need trimline or flange break line information then you would...