Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Grajan66
-
Deformable part
Hi John, I also had tried 'Sweep along Guide' but my problem was that i forgot to include the coordinate system for the direction of the sketch. I saw this in your attached file. Everything works fine now, thank you.- Grajan66
- Post #6
- Forum: Siemens: UG/NX
-
Deformable part
I have made an example. The cable should follow the curves like the tube and this with deformable parts. http://files.engineering.com/getfile.aspx?folder=96fe049b-2ff1-417c-9faa-46a2469761f0&file=Example.7z- Grajan66
- Post #4
- Forum: Siemens: UG/NX
-
Deformable part
Hello, Making a deformable part with a tube in assembly works fine, but when I try this with a different shape strange things happen. The shape deforms and the sweep starts at the position where the original has been created and not on the curve in the assembly. Is there anywhere a good tutorial...- Grajan66
- Thread
- Replies: 5
- Forum: Siemens: UG/NX
