Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Graeme Allison
-
Injection moulding question
Hi, I am looking at getting the attached part injection moulder, my worry is how the mould is produced with the internal slots, any advice is much appreciated. Regards...- Graeme Allison
- Thread
- Replies: 1
- Forum: Plastics Engineering general discussion
