Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by GParta
-
Torque_reg
Thanks for the suggestion Greg. The main aim is to input torque( function of time). In this project I'm mainly applying a revolute joint between the two arms and the motion described is AKISPL(Time,0,.world.Spline_1,0). Is this right? The time in the code is making it run only for 1 second...- GParta
- Post #3
- Forum: MSC.Software: ADAMS
-
Torque_reg
Hi everybody I would be grateful if someone could tell how I should input a torque as a function of time. The data runs around 400 samples. I actually used akspline. But the input time in spline data is 4 seconds and after simulating for 4 seconds my arm is rotating 4 times. What shall I do...- GParta
- Thread
- Replies: 3
- Forum: MSC.Software: ADAMS
