Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by gpape4

  1. gpape4

    Incoloy 800 HT Chart TM-4

    Has anyone found, or done themselves, the extrapolation for modulus of elasticity values on Incoloy 800HT material over 1500°F?
  2. gpape4

    ASME Flange Design

    TJOrlowski (Mechanical), BigTank (Mechanical), Thank you for the replies. I ended up finding a gasket, Grafoil GHR laminate, that solved the flange situation and then, Compress would not allow me to just PWHT the flange. Turned out that there was a bug in the program. Had to run the shell...
  3. gpape4

    ASME Flange Design

    Based on the information on the drawing from the old equipment file, it was an Armco soft iron. Based on an old Lamons catalog, m=3.25 and seating stress is 7,600.
  4. gpape4

    ASME Flange Design

    Trying to qualify an existing vessel with no existing paperwork. Built 1939. Everything checks out except for inspection opening. Non-standard flange, flat plate, intergral/slip-on. The deficiency report keeps failing the gasket seating or fails at the g1 weld requirement. Used existing info...
See more

Part and Inventory Search

Back
Top