Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by goucho

  1. goucho

    Annealing 321 Stainless

    I apologize for the double post. I know that some people only look at one forum so I figured I might as well get as much visibility as possible. I would delete the other post, but there doesn't seem to be an option to. Anyways, I am enjoying this discussion and I appreciate the responses. This...
  2. goucho

    Annealing 321 Stainless

    Thanks for the reply! If this is true, is there any benefit to annealing this ring? It's also interesting because we had tried this a couple years ago with an older Outer ring and apparently it shrunk in diameter closer to nominal. We never ended up running it any more though and it's been...
  3. goucho

    Annelaing 321 stainless

    I wasn't sure where to post this so I posted it in the Metal and Metallurgy forum as well (http://www.eng-tips.com/viewthread.cfm?qid=375377). I would like to anneal 321 at 1900F and what to know how it will react. Here's my case: We've been thermal forming a piece of 6-4 Ti between an inner...
  4. goucho

    Annealing 321 Stainless

    I wasn't sure whether to post this in the steel forum or not. I would like to anneal 321 at 1900F and what to know how it will react. Here's my case: We've been thermal forming a piece of 6-4 Ti between an inner ring of 321 and an outer ring of 410. The 6-4 piece is about 9 ft in diameter (in...
  5. goucho

    Customize Hole callouts

    So is there a separate area to set these hole callout annotations? Or is this always going to be a manual thing after you create the hole callout. The new feature is a beautiful thing and it's great that you can customize the prefix/suffix. It gets me 95% of the way there, however it would be...
  6. goucho

    Customize Hole callouts

    Thanks for the idea bbylls. Unfortunately it didn't work. I'm surprised it's not working though. I was wondering if it's because I made a custom Drafting Standards file, but within that that drafting standards in Customer Defaults the "Annotation Template Part" is listed as "ansi" so it should...
  7. goucho

    Customize Hole callouts

    When you use the Hole command in NX9.0 and dimension it in drafting, a standard text template is used. I was able to modify that by customizing the Hole Callouts in CUSTOMER DEFAULTS->Drafting->General->Drafting Standard. The result can be seen below in the attached picture. However I would like...
  8. goucho

    Custom Hole Callout

    I appreciate the response! However this is the area I was referring to where the prefixes and suffixes get removed when the hole is a THRU hole. I also want to add a custom parameter to these hole callout designations.
  9. goucho

    Custom Hole Callout

    I have an advanced question that I'm hoping someone might have an answer or workaround for. I've setup a new drafting standards file and am trying to modify the Hole Callouts. I have specific Prefixes and Suffixes for the various hole features. I've found that when I have a THRU hole, it removes...
  10. goucho

    Random Point Selection Issue

    I've referenced this forum for quite a while but have never needed to post until now. I have to sets of data points taken from a CMM. When I select all of the data points in one set, it will number them in a difference order each time. I tried keeping the view the same but that did not work. I...
See more

Part and Inventory Search

Back
Top