Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by GoSabres

  1. GoSabres

    bend allowance for odd shapes

    The polyline method in ACAD has always worked for me. I have used it many times and have had very few times where it wasn't close (+/-.010") using CS (hot or cold rolled) or SS. Aluminum can be slightly more (+/-0.015"), but as long as you are not looking for precision then you should be...
See more

Part and Inventory Search

Back
Top Bottom