Thank you for the replies.
dinjin, the thickness of the girt is 7/16" and the panel is ~0.08in, it was hard to get too accurate of a measurement since the panels were on the building and the owner is unable to locate the drawings which would show this information. Keep in mind though that the...
So am I to assume then that in the design I should take it as a black and white issue, and if it does not meet these minimum guidelines I should treat it as not engaged at all?
Thanks for your reply.
I know this general topic has been dealt with elsewhere on this forum but the threads I visited never addressed the question I have. If it has been dealt with elsewhere feel free to provide me a link.
But basically I have some corrugated steel panels that are attached to the girts of a metal...
