Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Globy

  1. Globy

    Equal pipe length

    I have a new problem, how can I do the drawings? I do not how to dimension a spline?
  2. Globy

    Equal pipe length

    Yes I did notice, I also need to work that...but my biggest concern was doing the runners. Thanks again!
  3. Globy

    Equal pipe length

    filehttp://files.engineering.com/getfile.aspx?folder=d0d09b3d-16f7-4219-a872-83fa5911eb6d&file=Colectores4.SLDPRT
  4. Globy

    Equal pipe length

    I did not use the global variable, I just clicked smart dimension and inserted the desired dimension, is it the same correct? I did what you sugested with the splines, but I do not understand why sometimes the "tubes" seems to shrink, look at the 1 cylinder. Is it possible to add points to the...
  5. Globy

    Equal pipe length

    Thanks a lot, I'll try do what you are saying, and then post it here!
  6. Globy

    Equal pipe length

    Hello djhurayt, Thanks alot for the info. Here it is, I'm not sure if the splines have the same length, I used the smart dimension. Sorry I do not know how you set the length with the global variable...
  7. Globy

    Equal pipe length

    Hello, people How can I make equal length pipes? I tried equations but unsuccessfully. I tried with splines, and smart dimension the splines, but then if you change the position of the point, don't know why the total measure is not the same. It is attached the file. Regards David...
See more

Part and Inventory Search

Back
Top