Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by giorgos1001
-
LC1212 ALPHA 2 Parameters
PROGRESS: I have put all the parameters that you gave me, Laserninja and the machine is working manually, but at some point it gets an alarm when the x,y or z axis exceeds the limit. I dont know if that supposed to happen or this is how it works manually. Tomorrow morning i will try again to go...- giorgos1001
- Post #10
- Forum: Laser engineering
-
LC1212 ALPHA 2 Parameters
Laserninja, thank you very very much. I will get to it and i will inform you. Thanks again- giorgos1001
- Post #9
- Forum: Laser engineering
-
LC1212 ALPHA 2 Parameters
if somebody has the same machine and is willing to sell me a copy of their parameters backup i am very interested.- giorgos1001
- Post #6
- Forum: Laser engineering
-
LC1212 ALPHA 2 Parameters
Unfortunately i did not get any disks with it. We are located in Cyprus, Europe. I am waiting for the distributor of amada in Greece (which is the distributor for Cyprus also) to give us an offer for coming to fix the machine, but at the same time i am looking if i can find out something. I am...- giorgos1001
- Post #5
- Forum: Laser engineering
-
LC1212 ALPHA 2 Parameters
the parameters of over travel and some other staff, which i dont remember now as it is late evening here and i am not at the office. i will send you again tomorrow morning in detail. Basically, what was saved on the memory masterboard has been deleted.- giorgos1001
- Post #3
- Forum: Laser engineering
-
Help with cutting parameters
Dear laserdog, your charts from operator's manual can be used on an amada lc1212 alpha 2 (1500w) as well?- giorgos1001
- Post #30
- Forum: Laser engineering
-
LC1212 ALPHA 2 Parameters
Hi all, My first time to post here. I am a newbie on laser cutting machines and i have started recently to read the manual of the recently purchased amada lc1212 alpha 2. At the beginning when i have first started the machine there was an SRAM PARITY ERROR. I have read the FANUC 16LB manual and...- giorgos1001
- Thread
- Replies: 9
- Forum: Laser engineering
