Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by gill78

  1. gill78

    standard for blowdown

    Is there a standard which describes a certain amount of mass in a line where automatic blowdown is no longer required and manual blowdown will suffice. I have been asked to look into this and told it will be in a standard somewhere and I am looking in API and NORSOK, but with very little luck...
  2. gill78

    process control

    Matt, thank you for the request on info. I have been taken off this task as the info was already there and nobody had realised it. Regards, Gill78
  3. gill78

    process control

    I have been given the task of figuring out a control equation. I have a flowmeter in a line and the setpoint is in ppm. Any ideas on where I can start. I figure it is something like: Flow = Flow Measurement x ppm x y, but I am unsure what "y" could be.
See more

Part and Inventory Search

Back
Top Bottom