Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by gilea

  1. gilea

    Class A: Alias/ICEm settings vs. real outcome

    Hi again, thank you for the info. The reason for raising this question is that we made a comparison with a voxel modeller (Freeform) which can export in NURBS-based surfaces, which were analyzed in Alias. Time spent in voxel modelling i one third compared to surfacing... The same geometry...
  2. gilea

    Class A: Alias/ICEm settings vs. real outcome

    Hi HDS, I basically have an interest in 3 of them: steel sheet forming, alu sheet forming and injection moulded, all coated. A detail such as a front fender could work as an example. Still, a connection between more methods (inj mould patterned vs. glossy, RIM, and even textiles) and achieved...
  3. gilea

    Class A: Alias/ICEm settings vs. real outcome

    Wondering whether surface analysis (coloured grading of curvature) in Alias and ICEM correspond to real outcome in tooling? Recomended settings vs. milling/polishing tolerance? Are we being to concious about virtual curvature? (A lot of work can be saved here...) If coated, does paint add or...
See more

Part and Inventory Search

Back
Top