The spline shaft was used in a Byrd Planetary Reducer. It was a side fit with no excessive clearance when new. When the shaft came to me, it had been running for many years and had excessive wear.
I was wondering if anyone knew how much wear is acceptable on an 10T. External Straight-Sided Spline before a replacement is necessary. The Spline width was originally .540/.538" when new, I was wondering how much wear is acceptable. Is there a standard? The O.D. is 3.485" and the...
I am trying to determine how to calculate if there is enough material between the bore of a gear and the root of the tooth. The gear is a 24T spur gear, the O.D. is 6.768", the pitch is 4DP(25pa), the bore is 4.250", the width is 4.63", and the RPM is 363. Does anyone know where...
