Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by gearing_guy

  1. gearing_guy

    Unilateral Tolerance

    Thanks for your responses. I would never assume anything especially with this customer. The dimension is an Overall length. I was just looking if there is a standard way it should be written. I looked through specs and could not find anything when that specifically said when using double plus or...
  2. gearing_guy

    Unilateral Tolerance

    I have a print with a dimension of 98,5 and it's tolerance is -0,3 and -0,2. I understand the ideas behind double minus or plus tolerancing. I do not completely agree with it but that is not the point here. Normally I am always used to seeing the max size on top and the min size on the bottom...
See more

Part and Inventory Search

Back
Top