Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by gbircumshaw
-
lining up of HD lathe
Hi, i am having problems gitting the alignment right from center to center on a HD lathe which i operate. the tailstock has since been lifted from the lathe bed, and i am wondering if there is any kind of equipment to make the alignment process any easier/quicker. A previous job which was...- gbircumshaw
- Thread
- Replies: 8
- Forum: Mechanical engineering general discussion
