Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by gb1988
-
2" OD Buttweld Pipe
Good point Mike! Yes I am looking for dimension standards for 2" OD buttweld tubing or fittings (elbows, tees, etc). ASTM A269 specifies permissible variation for OD and wall thickness, but I was hoping to find something that would show center to face dimension, bend radius, etc. Again ASME...- gb1988
- Post #3
- Forum: Mechanical engineering general discussion
-
2" OD Buttweld Pipe
Is there standard dimensions for a 2" OD Buttweld Pipe? For example: bend radius, wall thickness, tolerances, etc? I ask because ASME 16.9 does not specify a 2" OD. It does however specify dimensions for a NPS of 2, but this is 2.38" OD. I was wondering if maybe ASTM has a standard set for...- gb1988
- Thread
- Replies: 8
- Forum: Mechanical engineering general discussion
