Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by gazzz

  1. gazzz

    Bike Carb Manifold

    Hi all, Well finally got manifold made(got some different carbs with better spacing)Don,t know when i,ll get around to trying them but will post when I do leshttp://files.engineering.com/getfile.aspx?folder=a785724f-8846-4477-92cb-10c941e8d047&file=DSC00697.JPG
  2. gazzz

    Bike Carb Manifold

    Yes not sure why, is it letting slide up a bit higher than it was before when air flows in like lifting needle? I know with SU,s we used to put thicker oil in dash pot to make it richer on acceleration, I remember years ago on the rollers having a Fiat with a long duration cam tuned(autograss...
  3. gazzz

    Bike Carb Manifold

    Thanks for the thread on the v8 was very interesting and give me my answer FOR GET IT I was surprised he had to put stronger springs in the carbs? when we put the AFR gauge on my friends conversion it was weak when throttle was opened flat spot untill we fitted the dyno softer springs it then...
  4. gazzz

    Bike Carb Manifold

    Hi, There honda blackbird carbs Fiat x19 engine, Think its probably best to get manifold made just very hard with the spacing regards gazhttp://files.engineering.com/getfile.aspx?folder=3df04b35-5e9c-449b-912a-6115569e7a15&file=DSC00689.JPG
  5. gazzz

    Bike Carb Manifold

    Hi pat, Thanks for reply, the reason for me wanting to do this is price first and second I could do this myself but any angles or bending I would have to pay some one, The runners are 7" long and angle up to the bottom of plen, The plen is 12" L by 2"D by 3"W nearly flat on top so would be easy...
  6. gazzz

    Bike Carb Manifold

    Hi all, I,m new to this forum but need some advise off any one who can help, I am thinking of running four bike carbs on a four cylinder engine but because the ports are spaced unusual(two ports next to each other then big gap to other two ports) I was going to use a std injection manifold (off...
See more

Part and Inventory Search

Back
Top