Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by gandco

  1. gandco

    image logo

    hi, is it possible to attache an image/logo to a part so you can render it in Virtual Studio+ ?
  2. gandco

    Center of gravity

    Is it possible to show the center of gravity of a part (.psm) in a draft?
  3. gandco

    Mass print option

    Thanks beachcomber - much appreciated
  4. gandco

    Mass print option

    Hi, Is there a mass print option with Solid Edge? Thanks in advance.
  5. gandco

    Sketches in draft

    Newcomer to the forum - This would be very helpful if you could see sketches in draft mode - is it possible?
See more

Part and Inventory Search

Back
Top Bottom