Eng-Tips is the largest forum for Engineering Professionals on the Internet.

Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!

Register Log in
  • Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Galbert99

  1. Galbert99

    problem with cyclic region of a gear in ansys mechanical

    I have resolved using "stage" in symmetry, but I still have mesh problems using a method in the mesh generation so I have to use a mesh made by tetrahedrons instead of hexahedrons
  2. Galbert99

    problem with cyclic region of a gear in ansys mechanical

    thank you for answer if I change the sizing behaviour on "soft" I still have the same problem, I still have the problem even if I use no meshing method and using a bigger element size. Without the cyclic region the mesh at the low and high face is the same
  3. Galbert99

    problem with cyclic region of a gear in ansys mechanical

    Good morning I'm doing a static structural analysys of a gear in ansys workbench. I designed the gear in catia v5 and I have imported the geometry in ansys discovery where I have split the gear. In ansys mechanical I have problems using "cyclic region", the mesh is distorted and I don't...
  4. Galbert99

    multi section catia

    Thank you for answer. It doesn't work also with guides, it tells me that the extrusion of a vertex of the profile leads to a cusp, I've tried also to change closing points
  5. Galbert99

    multi section catia

    Hi guys, I'm drawing a compressor blade in Catia v5 but multi section doesn't work and I don't understand why. I forward a picture of what I see
  6. Galbert99

    How can I use the modal analysis of a wind turbine?

    Good morning everyone, I have to do a vibration mechanics project for university and I was thinking of doing the modal analysis of a wind turbine, only I don't know how to evaluate the results I get, with what I should compare the frequencies relating to the modes of vibrate? Thanks in advance
See more

Part and Inventory Search

Back
Top