this may be unrelated but i'll post it in case it helps speed things up. I find that if I'm working off the server things don't work as fast as if i'm working off my hard drive. Even simple commands seem to lag if the server is very busy. keep that in mind.
I aggree with the previous 2 posts. I love using top down modelling techniques like skeletal modelling or by driving dimensions using a spreadsheet. Top down modelling is a little trickier than bottom up modelling but there has been times where it has saved me many hours of design time. It's...
I'm sorry but you're wrong. Read up on the subject here.
http://en.wikipedia.org/wiki/Isometric_projection
Isometric views are not projections of the true image because the sides are supposed to be equal length.
I would like to attain true isometric views from inventor not representations.
I was just recently informed that the isometrics that inventor inserts into it's drawings are not to scale. A quick measurement confirmed this to be so. Is there a way to ensure they come in at their proper scale?
I find that paying attention to the little 3d arrows has helped me a lot and I only get it wrong once in a while. There is a pattern there but it's not very obvious. With the flush constraint I find that if you select the first face of the first part and then select the face of the second part a...
Yes I do mean positional representations. I am having problems with their updates. They don't always update properly and I sometimes get errors. I am fairly new with this program despite learning about it in school. Is there a way to ensure that the positional representation is progressively...
I am finding positions to be very confusing. Sometimes they work and sometimes they don't. Does anyone have tricks on making these things work right. Or does someone have tricks that could help me reduce the number of errors that I accrue in my assemblies? I am new to inventor and am getting...
