Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by g114

  1. g114

    Info. Aircraft Tank loaders aboard carriers

    Hello Group, When I was on the USS Roosevelt, the munitions handelers would load the fuel tanks and munitions under the wings of the fixed wing aircrafts using a 4 or more wheeled dolly that had a craddle area to hold the tank/weapon while being lifted up to the wing. Does anyone know what the...
  2. g114

    Looking for a mosfet with..

    Thanks, to all that have replied. The application is a switch for applying pulse widths of various widths and voltage magnitudes to a terminator to determine the amount of shift the terminator experiences.
  3. g114

    Looking for a mosfet with..

    I mean, I would like to use the device to create pulses of 1us, 10us,... up to 50us. I will look at IGBT's. Thank you.
  4. g114

    Looking for a mosfet with..

    I would like to switch between 1us and 50 us.
  5. g114

    Looking for a mosfet with..

    Looking for a mosfet with: 1600-2000V Vces rating; 30A Ic rating; and low Rds(on. I've looked at Digi-Key and Mouser and found IXYS's 40N160, but would like an alternate. Thanks in advance.
  6. g114

    Attenuator S parameters

    Hello All, Excuse me for asking what probably is a question with an obvious answer, but if an attenuator's S21 parameter is smooth for a given bandwidth, should the S11 parameter also be smooth for that bandwidth? I would think yes, but my measurements seem to indicate otherwise.
  7. g114

    3-port resistor

    It is a 50ohm surface mount thin film resistor. Thanks to all that responded!
  8. g114

    3-port resistor

    Hello all, Hope this is the right forum for this question. I have a resistor with one input terminal and two output terminals. At first glance, I thought the device is a power splitter (or combiner), but it is not characterized as one. So, what type applications would a three terminal...
  9. g114

    IBIS modeling

    I have looked at the North Carolina State University software, but have been told the results were unreliable. Is this true? thanks, g114
  10. g114

    IBIS modeling

    Hello Anyone, Does anyone know of commercially available software for generating IBIS models from PSPICE or HSPICE models? As I am new to the whole idea of IBIS modeling, any experience anyone would like to share with me about developing models for passive SMDs would be appreciated. I have...
  11. g114

    Aluminum Nitride

    Thanks kenvlach
  12. g114

    Aluminum Nitride

    Could anyone point me in a direction where I could find out more information about AIN?
  13. g114

    Aluminum Nitride

    Anyone know of a good supplier of AIN?
  14. g114

    RFSim99 Help

    Is there already an existing forum/thread on RFSim99? I would like to know if the software is capable of generating a VSWR graph. Additionally, the graph that it generates does not allow for much display modification. Am I expecting to much from freeware?
See more

Part and Inventory Search

Back
Top