Recent content by FXjohn

you're better off making the titleblock in UG, exporting a PDF, and then combining them in another program.

we are migrating from 7.5 to 8.0, thanks I will look at your videos

here is the picturehttp://files.engineering.com/getfile.aspx?folder=1eccd5b7-53f8-471e-b694-9119a628b50f&file=t-block_test.JPG

How do I nest images, sch as the third angle projection symbol as shown? (see picture)

For the most part I'd be satisfied with a flat pattern, even if it was just wirefrane. the system doesn't seem to be able to unfold dents or the wall corners. I will look into the progressive die module

I have NX 7.5 NX sheet metal application. take a look at this picture http://files.engineering.com/getfile.aspx?folder=b5b5c0d1-dbb7-4207-b383-a3d2aafb284e&file=NGE_Puzzle-Piece_Design_11_5-29-2014.jpg

It was in the settings in NX. edit it to as saved. never mind

Has anyone done much of this? so far I can get an assembly, but it doesn't seem to bring along the children in the original NX file that were in other directories. just the components from the same directory as the assembly itself I start a blank product and use insert existing component and...

thanks, FrankSwinks. good work

hey that is a good idea, thank you

here is the UG filehttp://files.engineering.com/getfile.aspx?folder=1bd4a37f-8706-4e12-ab6f-fa0d4a7492a1&file=wire_cover.prt

I'm trying to make a design out of helical wrapped wire that makes a cylinder and the ends in a half sphere. I;m not sure how to apply the law curve function to do that. NX 7.5 see attached picture and UG file thanks

actually it doesn't work so good. since it's skewed in 3D it doesn't draw the smallest possible box

That works great! thank you very much, Joyce

I don't have an advanced assembly license but I need to figure out how to draw a part with the minimal XYZ box so I can package it. what's the easiest way to do it? UGNX 7.5.2.5 see attachment, and thank you very much