Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by ftiphain

  1. ftiphain

    Shell elements

    Hi! is it possible under abaqus viewer to recover the values of the mid surface of the shell elements ? I know that is possible for SPOS and SNEG surfaces !! Thank you
  2. ftiphain

    Transverse shear stiffness

    Hi!! Here, I modelled my structure with shell elements S3 and S4. For the validity of the study I must use a UMAT. When I carry out calculation, abaqus writes to me in the .dat: ***WARNING: TRANSVERSE SHEAR STIFFNESSES ARE NOT DEFINED FOR THIS USER DEFINED MATERIAL(UMAT)...
  3. ftiphain

    boundary conditions

    in fact i would like to lock one or more elements, in order to modelize points of electric welding. I would like to block elements as one can block nodes with the order: . . *BOUNDARY NODE_SET, ENCASTRE . .
  4. ftiphain

    boundary conditions

    hello, here I wanted to know if it was possible to define boundary conditions on a surface and not on nodes? it is to model points of electric welding? thank you
  5. ftiphain

    How to use a UMAT

    ok thank u
  6. ftiphain

    How to use a UMAT

    I mean how to use an existing UMAT ?
  7. ftiphain

    How to use a UMAT

    Hello, I will have to use a UMAT. - it would be possible that somebody indicates the procedure to me to make use of it? Thank you in advance.
See more

Part and Inventory Search

Back
Top Bottom