What is the best motor type to use for the following application?:
A portable tool (variable torque) operating at 24 VDC needing 1/2 hp full load at 10,000 rpm. Continuous operation, overall motor life at least 200 hours, speed control all required.
I am in need of small planet gears of the following nominal specification:
Length - 17 mm
Bore - 13 mm ground Ra 8
Teeth - 24
Rack Profile - DIN 867
Pitch dia. - 19.2 mm
Pressure angle - 20 degrees
Hardness - case hardened to Rc 58
I can provide a drawing. Any leads greatly appreciated.
FTI
I am currently prototype testing a single stage planetary gear that is a 5:1 reduction with an input speed/hp of 3500 rpm/1-1/2 hp. It is all steel in construction and is contained in an aluminum housing. This gear was chosen for its small size, low mass and high efficiency. It is being used as...
