Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Freesum
-
Surface Callout for air-tight mating
The top plate only bends when affixed to the frame. If it's unconstrained, it has room to expand and contract appropriately. From my understanding, a single sheet of metal heated evenly shouldn't warp from heat alone. I'm considering a flexible sealant that will allow for thermal expansion...- Freesum
- Post #4
- Forum: Drafting Standards, GD&T & Tolerance Analysis
-
Surface Callout for air-tight mating
New to this site. Hoping I can get a question answered as I don't really have experience with surfacing. I have two surfaces that need to create a gas tight seal but cannot be mechanically affixed to each other due to warping that will occur from thermal expansion in use. My solution was to...- Freesum
- Thread
- Replies: 5
- Forum: Drafting Standards, GD&T & Tolerance Analysis
