Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by FredFlatstone
-
Square bar through bearing?
Yes, perhaps you are correct there Mike! [bigsmile] I'm not too well versed with MechEng so wasn't quite sure. Thanks for your input.- FredFlatstone
- Post #3
- Forum: Mechanical engineering general discussion
-
Square bar through bearing?
I have a project that calls for an 8mm rod through a number of bearings. The bearings use a set screw, which means that ideally a flat edge is called for to give the set screw something to hold to. I'm wondering, rather than go through the extra machining costs, could I use a square bar, or...- FredFlatstone
- Thread
- Replies: 9
- Forum: Mechanical engineering general discussion
