Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Fred4

  1. Fred4

    Upright FEA correct?

    ok, Thank you for your answer. I will do this the other way round, too. Are they other prof. methodes to calculate an Upright?
  2. Fred4

    Upright FEA correct?

    Hello, i´ve a question about FEA. I designed an upright for a virtual car. I want to check if that upright is big/stiff enough, but i´m not sure if my FEM model is correct. The bearing cup I fix in all 6 DOF on these two surfaces you can see in the picture. The forces I applied at the holes...
See more

Part and Inventory Search

Back
Top Bottom