Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by FOM1
-
Super Austenitic vs. Duplex/Super/Hyper Duplex Stainless Steels
I found some ACOM magazines; A CORROSION MANAGEMENT AND APPLICATIONS ENGINEERING MAGAZINE FROM OUTOKUMPU- FOM1
- Post #8
- Forum: Metal and Metallurgy engineering
-
Super Austenitic vs. Duplex/Super/Hyper Duplex Stainless Steels
ironic metallurgist I've not found the site for the ACOM, there are hundreds of hits and I've opened about 50 pages of meaningless dribble, any additional clues to this ACOM such as key words? I've been thru the Outokumpu handbook, the NIDI, IMOA, EuroInox, Atlas, Nickel Institute, Arcelor...- FOM1
- Post #4
- Forum: Metal and Metallurgy engineering
-
Super Austenitic vs. Duplex/Super/Hyper Duplex Stainless Steels
I'm searching for the most definitive guide & reference for corrosion resistance factors, such as PREN, CCCT & CPT for the super austenitic (254/64SMO, 904L & AL6XN) vs. (2205,2507 & 2707). I've been searching the net and find article for 1 or 2 of these materials, but nothing comprehensive or...- FOM1
- Thread
- Replies: 8
- Forum: Metal and Metallurgy engineering
-
AISI 4150 w/ 1200 degree temper for BHN 321/341 Fatigue/Endurance/SN Curve, 10" nominal diamete
Hello ETips, I looking for a reference, article, paper or other source that may list the endurance/SN/Fatigue curve for the listed material, any suggestions avail are appreciated.- FOM1
- Thread
- Replies: 1
- Forum: Mechanical engineering general discussion
