Many thanks for the info;
Yes each cylinder liner is low at one side and taller at the other, from the Crank Shaft Centre Line, we are only talking about 0.005" to 0.010" I think Mac is right about the deck heights of each liner, and the tilt when boring.
The Mains have been reduced from 2.749...
Many thanks for the updates.
As you can tell I have an Alloy Block; which recently had some major work completed by a "recognised engineer" and I need to understand why some measurements appear to suggest that the work done is not correct.
I understand that all engine blocks, whether Cast Iron...
Hi all; was hoping that somebody could advise on the following;
I will try to explain, but you may find my inexperience in describing what I am trying to find out, a little confusing, sorry
There is always a lot of discussion on the effects of Torque Plate Twist on cylinder bores.
What effect...
