Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by flameon
-
can you cut 1/2" mild steel
first go to a 7.5 in. focus lens, it will give you a wider kerf and allow more metal to flow. second, move the focus above the matrl about 2mm and use very low oxy gas pressure about .5 kg. use 1500 watts/80-90% duty. try the freq. at 1300 then 500, 25 ipm as a start point . i'm not too sure how...- flameon
- Post #3
- Forum: Laser engineering
-
Best Five Axis Laser? Input Please
you will not make a mistake if you buy from one of the top 5 in the u.s. mitsubishi, amada, trumpf, bystro, mazak. service and post sale support will be critical. be careful anywhere else unless you can rebuild the machine yourself. software is the key, you'll need software that can generate...- flameon
- Post #7
- Forum: Laser engineering
