Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by fetchballer
-
virtual condition for multisegment hole callout
Hello, I have just started learning about GD&T, and my question is as below: A basic sketch is attached. When a hole is located using a position tolerance and refined using a perpendicularity tolerance (both of which have the MMC modifier), what is the virtual condition(s) of the hole and why...- fetchballer
- Thread
- Replies: 1
- Forum: Drafting Standards, GD&T & Tolerance Analysis
